News Center
Blog
Miteqi Vacuum Cleaner Fault Analysis
Release time:2019-05-27
I. Fault Symptom: Motor Not Turning—Possible Causes: 1. The power plug is not properly inserted; 2. The power outlet has no power; 3. The vacuum cleaner’s power switch is not turned on; 4. The motor is burned out. Troubleshooting Measures: 1. Recheck and ensure the plug is securely inserted; 2. Make sure the power outlet has power; 3. Turn on the switch; 4. Replace the motor. II. Fault Symptom: Motor Burnout—Possible Causes: 1. The current exceeds the rated load, causing blockage and prolonged formation of a vacuum load; 2. Dust has entered the motor; 3. Sewage, foam, or other contaminants have entered the motor. Troubleshooting Measures: 1. Check the power supply and voltage; 2. Repair the motor. III. Fault Symptom: Reduced Suction—Possible Causes: 1. The dust filter is clogged; 2. The air intake is blocked; 3. The hose or nozzle is partially obstructed; 4. The suction pipe is bent or kinked.
1. Fault phenomenon: The motor does not rotate.
Possible causes:
1. The power plug is not properly inserted;
2. The power outlet has no power;
3. The vacuum cleaner’s power is not turned on;
4. The motor is burned out.
Handling method:
1. Recheck and make sure the plug is properly inserted;
2. Make sure the power outlet has power;
3. Turn on the switch;
4. Replace the motor.
II. Fault Phenomenon:
The motor burned out.
Possible causes: 1. The current exceeds the rated load, causing blockage and prolonged formation of vacuum negative pressure.
Lotus;
2. Dust has entered the motor;
3. Sewage foam and the like enter the motor.
Solution: 1. Check the power supply and voltage;
2. Motor repair.
3. Fault phenomenon: Reduced suction power
Possible causes: 1. Dust cover, filter, nozzle, vacuum hose, vacuum cleaner steel
Pipe blockage;
2. The nozzle, vacuum hose, and vacuum steel pipe are damaged.
Handling method: 1. Empty the dustbin;
2. Remove any blockages from the vacuum cleaner and the vacuum hose.
3. Clean or replace the filter bags.
4. Fault phenomenon: Dust spills out during vacuuming.
Possible cause: The dust filter is improperly installed or damaged.
Solution: 1. Check whether the filter bag is installed in the correct position.
2. Check whether the filter bags are damaged;
3. Inspect the seals.
The previous one
The previous one
More blogs
Room 1010, South Tower, Xinda City Plaza, No. 27, Second Horizontal Road, Shuiyin Road, Yuexiu District, Guangzhou, China