What should I do if the water suction blade on a ride-on floor scrubber isn't performing well?

Release time:2022-11-10

When ride-on floor scrubbers are frequently misused—such as being employed to clean excessively large surfaces that exceed the machine’s technical capabilities, or when the equipment is simply unsuitable for the type of task at hand—you may encounter certain problems and some potential solutions. 1. Check whether the squeegee rubber strip is clean and free of any solid debris lodged inside it. 2. Replace any damaged rubber strips. Adjust the angle of the squeegee. For proper operation, the squeegee’s height should be adjusted according to the wear condition of the rubber strip; during cleaning, the rear rubber strip should bend backward by 5 mm along its length. 3. Verify that the suction hose has been correctly inserted into the inlet of the wastewater tank. 4. Remove the suction units and clean them thoroughly. 5. Confirm that the switch for the suction motor is turned on. 6. Check the adjustment of the water squeegee wheels.

1

Check whether the rubber strip of the water squeegee is clean and whether any solid residues are left inside.
2

Replace the damaged rubber strip. Adjust the angle of the squeegee. For proper use, the squeegee’s height should be adjusted according to the wear condition of the rubber strip; during cleaning, the rear rubber strip should be bent backward by 5 mm along its length.
3

Check whether the suction pipe has been properly inserted into the inlet of the sewage tank.
4

Remove the water-absorbing units and please wash them.
5

Check whether the water-absorbing motor switch is turned on.
6

Check the adjustment of the water rake wheel.