Why isn’t the floor scrubber absorbing water anymore?

Release time:2021-03-08

The Miteqi floor scrubber fails to effectively suction up dirty water mainly due to the following reasons: 1. The water-absorbing rubber pad has accumulated a lot of debris, which prevents it from fully absorbing water and leaves behind streaky watermarks. In this case, simply removing the debris from the rubber pad will restore its normal functionality.

The main reasons why the Miteqi floor scrubber doesn't effectively suction up dirty water are as follows:

1. The absorbent rubber surface has accumulated a lot of debris, causing it to fail to absorb water effectively and leaving behind streaky watermarks. In this case, simply removing the debris from the rubber surface will restore its normal functionality.

2. Is the sewage suction pipe blocked?

3. Is the float in the sewage tank stuck?

4. Is the lid on the sewage tank closed?

5. Regularly check the vulnerable parts to ensure that the suction device is not damaged.

6. Is the wastewater level too high and not being drained away?

These are the primary factors that directly affect suction power.